Sloop

From Wikipedia, the free encyclopedia
Jump to: navigation, search
For the military definition of sloop see: Sloop-of-war.
The sail plan of a typical "Bermuda" sloop.
For the open learning project see: SLOOP Project.

A sloop (from Dutch sloep, in turn from French chaloupe) is a sail boat with a fore-and-aft rig and a single mast farther forward than the mast of a cutter.

A sloop's fore-triangle is smaller than a cutter's, and unlike a cutter, a sloop usually bends only one headsail, though this distinction is not definitive; some sloops, such as the Friendship Sloop, have more than one. Ultimately, the position of the mast is the most important factor in determining whether a ship is classified as a sloop.[citation needed]

The majority of modern sailboats are sloops, or, to put it another way; most modern sailboats are sloop-rigged. A typical modern sloop carries a mainsail on a boom aft of the mast, and a single headsail (a jib or a genoa jib) forward of the mast.

Modern sloops may be further divided into masthead-rigged sloops and fractional-rigged sloops. In the case of the masthead-rigged sloop, the forestay (on which the headsail is carried) attaches at the top of the mast. On a masthead-rigged sloop, the headsail is often larger than the mainsail. This is especially true if the headsail is a large genoa jib. In the case of a fractional-rigged sloop, the forestay attaches to the mast at a point below the top. It might attach 3/4 of the way to top, or perhaps 7/8 or some other fraction. This is the origin of the term fractional-rigged. The mast of a fractional-rigged sloop is also usually placed farther forward, and compared to a masthead-rigged sloop, this results in a much smaller jib relative to the size of the mainsail. The J-24 (pictured) has a fractional rig.

Contents

[edit] Rationale behind the sloop rig

Typical Bermuda rigged sloop

The sloop rig is one of the simpler sailing rig configurations (the cat rig, having only a mainsail is the simplest). A sloop almost always has two sails, a mainsail and a jib. A cutter, the next most complex rig has a single mast and usually has three sails. The next most complex rigs are the ketch and the yawl, each of which have two masts and have three sails in their simplest forms.

By dividing the total sail area into only two sails, the individual sails of a sloop are larger than those of a similar sized cutter or yawl or ketch. Until the advent of light weight modern sailcloth and modern sail handling systems, the larger sails of a sloop were somewhat of a disadvantage. Therefore, until the middle of the 20th century, rigs other than the sloop (cutters and ketches and yawls) were often preferred for sailboats exceeding 10 meters in length. After the advent of modern winches and modern sailcloth, the sloop became the dominant sailing rig type for all but the largest sailboats.

No rig type is perfect for all conditions. Sloops, with their minimal amount of spars and control lines tend to impart less aerodynamic drag. Compared to other types, sloops therefore tend to perform very well when sailing upwind (also known as sailing to windward or sailing close hauled). However, sloops also offer an excellent overall compromise of abilities on all points of sail.

Cutters and ketches and yawls are often still preferred to sloops when venturing far offshore. With only two sails, it is more difficult for a sloop to reduce sail as the wind increases, while still keeping the boat balanced.

[edit] Sails carried

A sloop-rigged J/24 sailboat

To maximize the amount of sail carried, the classic sloop may use a bowsprit, which is essentially a spar that projects forward from the bow of the boat. For downwind sailing, the typical foresail may be replaced (or sometimes supplemented) by larger curved sails known as spinnakers or gennakers. The typical foresail, known as the jib, which does not overlap the mast more than 10 to 20 percent, may be replaced by a genoa, which overlaps the mast by as much as 55 to 100 percent, for racing rules, and sometimes more. The mainsail and genoa form an efficient double wing[citation needed].

[edit] The Bermuda Sloop

The modern yachting sloop is known as the Bermuda sloop, due to its Bermuda rig (also known as the Marconi rig, due to its resemblance to the wireless towers of Guglielmo Marconi), which is the optimal rig for upwind sailing; consequently sloops are popular with sport sailors and yachtsmen, and for racing. The rig is simple in its basic form, yet when tuned properly, it is maneuverable and fast. The main disadvantage is the relatively large size of the sails, especially on larger vessels. It is also less successful sailing downwind; the addition of a spinnaker is necessary for faster downwind speed in all but the strongest winds, and the spinnaker is an intrinsically unstable sail requiring continual trimming[citation needed].

The Bermuda sloop is a type of fore-and-aft rigged sailing vessel developed on the island of Bermuda in the 17th century. In this sense, the term is applied to small ships, rather than boats. In its purest form, it is single-masted, although ships with such rigging were built with as many as three masts. Its original form had gaff rig, but evolved to use what is now known as Bermuda rig, making it the basis of nearly all modern sailing yachts. Although the Bermuda sloop is often described as a development of the narrower-beamed Jamaica sloop, which dates from the 1670s, the high, raked masts and triangular sails of its Bermuda rig are rooted in a tradition of Bermudian boat design dating from the early 17th century. Part of that tradition included long, horizontal bowsprits and large jibs. Three jibs were commonly used on Bermudian ships. Triangular sails appeared on Bermudian boats early in the 17th century, a development of the Dutch bezaan, or leg-of-mutton rig, itself derived from the Lateen rig. This became the Bermuda rig, and was appearing on Bermudian ships by the early 19th century. A large spinnaker was carried on a spinnaker boom, when running down-wind.

[edit] Jamaican Sloop

Jamaican Sloops were slightly different from Bermuda Sloops, the most obvious difference being that these ships were built on the shores of Jamaica. Their beams were narrower than ocean-going Bermuda sloops, and they carried gaff rig, where Bermuda sloops might carry gaff or Bermuda rig. The keel for Jamaican sloops would usually be between 50–75 feet, but could be built longer. They usually had a speed of around 12 knots, which is equivalent to about 13 mph.[1] The sloops were built near the shore and usually out of cedar trees, since these were very resistant to rot, grew very fast and tall, and had a taste displeasing to animals.[2] One of the reasons why Jamaican sloops were built out of cedar, and not oak, was because of the specific properties of cedar. The oak that would normally be used would rot in about 10 years, while cedar would last for close to 30, and was considerably lighter than oak, as well.[2] The change in weight also made the ships made of cedar faster and more able to maneuver quickly.

Since piracy was a significant threat in Caribbean waters, merchants sought ships that could outrun pursuers. Ironically, that same speed and maneuverability made them highly prized and even more targeted by the pirates they were designed to avoid.

When the ship had to be careened, pirates needed a safe haven on which to ground the ship. Sloops were well suited for this because they were able to sail in shallow areas where larger ships would either run aground or be unable to sail through at all. These shallow waters also provided protection from many of the naval ships of the English, which tended to be larger and required deep water to sail safely.[2]

[edit] Historic naval definition

A three-masted Bermuda sloop of the Royal Navy, ca. 1831. Also called Ballyhou schooners, the RN referred to these as sloops-of-war.

The naval term "sloop" referred to ships with different rigs and sizes varying from navy to navy. "Sloop-of-war" was more of a reference to the purpose of the craft, rather than to the specific size or sailplan. (Further confusion was caused by the practice of redesignating a vessel simply according to the rank of the commanding officer.) The Royal Navy began buying Bermuda sloops, beginning with an order for three sloops-of-war (HMS Dasher, HMS Driver, and HMS Hunter, which were each of 200 tons, armed with twelve 24 pounders) placed with Bermudian builders in 1795. They were intended to counter the menace of French privateers, which the Navy's ships-of-the-line were ill-designed to counter[citation needed].

Eventually, Bermuda sloops became the standard advice vessels of the navy, used for communications, reconnoitering, anti-slaving, anti-smuggling, and other roles to which they were well suited. The most notable examples of these were HMS Pickle, which raced back to England with news of the British victory and the death of Admiral Lord Nelson at the end of the Battle of Trafalgar, and HMS Whiting (79 tons and four guns), which lowered anchor in the harbor of Hampton Roads on 8 July 1812, carrying dispatches. The American privateer Dash, which happened to be leaving port, seized the vessel. The crew of Whiting had not yet received news of the American declaration of war, and her capture was the first naval action of the American War of 1812[citation needed].

Generally, a sloop was smaller than a frigate; however, in the later days of the U.S. Navy's sailing fleet, some of the largest vessels were called sloops because they carried fewer guns than a frigate, as few as 20. The classification of sloop was similar to that of a corvette.

[edit] Modern naval definition

In modern usage, a sloop refers to a warship between a corvette and a frigate in size. Such vessels were common during the age of steam, but ships of this type were becoming obsolete by the Second World War. The Royal Navy used sloops, such as those of the Flower class, in numerous roles, including escort duty and anti-submarine warfare, during World War I. The same was true during the Second World War, when the Royal Navy used the Black Swan class. During World War II, several Royal Navy sloops destroyed five German submarines.

[edit] Modern civilian connotation

A 20th Century IOD sloop and a 19th Century Bermudian working sloop in Bermuda.

Sloops in their modern form were developed by the French Navy as blockade runners to circumvent Royal Navy blockades. They were later adapted to pilot boats (small ships that took a pilot out to a ship, to guide it into a harbor). Later still, they were adapted to smaller revenue cutters.[citation needed]

The first modern sloops were fitted with the Bermuda rig, so called as a result of its development in Bermuda, during the 17th century. This rig is also called the Marconi rig because of the resemblance of its tall mast and complex standing rigging to Guglielmo Marconi's wireless (radio) transmission antennas.

The state of the art in racing sloops, today, may be seen in the IACC yachts sailed in the America's Cup competition. This statement is only true in that the most money has been spent in this class, to build the fastest boats that meet the IACC rules. Much faster sloops have been built that do not fit the rules, using such forbidden technology as canting keels and movable water ballast. The current Volvo Ocean Race is using a new class, the Volvo 70, which boasts a canting keel, carbon construction throughout, and very powerful sailplans. The 24-hour distance record was recently broken several times, with ABN AMRO 2 setting the record distance of 563 nautical miles (1,043 km) for a monohull (January 2006). These boats routinely sail at or above wind speeds and can sustain mid-20-knot (37 km/h) speeds hour after hour.[citation needed]

The largest yachting sloop built to date is Mirabella V, with a carbon-fiber mast that is 289 feet (90 m) high.

[edit] See also

[edit] Notes

  1. ^ Konstam, Angus. 2007. Pirates: Predators of the Seas. 23–25.
  2. ^ a b c Evans, Amanda M. 2007. Defining Jamaica Sloops: A Preliminary Model for Identifying an Abstract Concept. Journal of Maritime Archaeology, 2 (2) (October): 83–92.

[edit] Bibliography

  • Rousmaniere, John, The Annapolis Book of Seamanship, Simon & Shuster, 1999
  • Chapman Book of Piloting (various contributors), Hearst Corporation, 1999
  • Herreshoff, Halsey (consulting editor), The Sailor’s Handbook, Little Brown and Company, 1983
  • Seidman, David, The Complete Sailor, International Marine, 1995
  • Jobson, Gary, Sailing Fundamentals, Simon & Shuster, 1987

[edit] External links

Personal tools
Namespaces

Variants
Actions
Navigation
Interaction
Toolbox
Print/export
Languages